Information for newport Users Guido Günther 24 February 2003 1. Supported Hardware This is an unaccelerated driver for the SGI newport cards (a.k.a. XL) as found in the SGI Indy and Indigo2. Both the 8bit and 24bit versions are tested and working. 2. Features o Support for 8 and 24 bit pixel depths o Hardware cursor support to reduce flicker 3. Notes o X -configure does not generate a XF86Config file. o There's only a 1280x1024 mode. 4. Configuration The driver auto-detects all device information necessary to initialize the card on the Indy. The only lines you need in the "Device" section of your XF86Config file are: Section "Device" Identifier "SGI newport" Driver "newport" EndSection Indigo2 users have to use the BusID option as documented below. However, if you have problems with auto-detection, you can specify: o bitplanes - number of physical bitplanes (8 or 24) o HWCursor - enable or disable hardware cursor o BusID - set this to "1" on the Indigo2 XL 5. Authors o Guido Guenther 6. Acknowledgements o Gleb O. Raiko for getting the beast to build o Ralf Baechle for his patience... o Ulf Carlsson for comments and elf loader code o Nina A. Podolskaya for elf loader code o all the guys who wrote the newport_con linux kernel code Generated from XFree86: xc/programs/Xserver/hw/xfree86/doc/sgml/newport.sgml,v 1.6 2003/02/25 19:31:02 dawes Exp $